Print
MIC5801

MIC5801: 4/8-Bit Parallel-Input Latched Drivers

Key Features
  • 4.4MHz Minimum Data Input Rate
  • High-Voltage, Current Sink Outputs
  • Output Transient Protection
  • CMOS, PMOS, NMOS, and TTL Compatible Inputs
  • Internal Pull-Down Resistors
  • Low-Power CMOS Latches
Typical Application



Enlarge View

Related Information

Data Sheet
Product Brief
Eval Boards or Kit
Software Package / Kit
Application Notes
Package Outlines
MICRELSim Center
SPICE / IBIS Models
Distributor Stock Check
Free Samples
Press Releases
  Related Literature:
Applications
  • 4.4MHz Minimum Data Input Rate
  • High-Voltage Current Sink Outputs
  • Output Transient Protection
  • CMOS, PMOS, NMOS, and TTL Compatible Inputs
  • Internal Pull-Down Resistors
  • Low-Power CMOS Latches


General Description

The MIC5800/5801 latched drivers are high-voltage, high-current integrated circuits comprised of four or eight CMOS data latches, a bipolar Darlington transistor driver for each latch, and CMOS control circuitry for the common CLEAR, STROBE, and OUTPUT ENABLE functions.

The bipolar/MOS combination provides an extremely low-power latch with maximum interface flexibility. MIC5800 contains four latched drivers; MIC5801 contains eight latched drivers.

Data input rates are greatly improved in these devices. With a 5V supply, they will typically operate at better than 5MHz. With a 12V supply, significantly higher speeds are obtained.The CMOS inputs are compatible with standard CMOS, PMOS, and NMOS circuits. TTL or DTL circuits may require the use of appropriate pull-up resistors. The bipolar outputs are suitable for use with relays, solenoids, stepping motors, LED or incandescent displays, and other high-power loads.Both units have open-collector outputs and integral diodes for inductive load transient suppression. The output transistors are capable of sinking 500mA and will sustain at least 50V in the OFF state. Because of limitations on package power dissipation, the simultaneous operation of all drivers at maximum rated current can only be accomplished by a reduction in duty cycle. Outputs may be paralleled for higher load current capability.

Ordering Information
Part Number Temp. Range Package
Standard Pb-Free
MIC5800BN MIC5800YN 0°C to +85°C 14-Pin Plastic DIP
MIC5800BM MIC5800YM 0°C to +85°C 14-Pin SOIC
MIC5801BN MIC5801YN 0°C to +85°C 22-Pin Plastic DIP
5962-8764001WA1 -- 0°C to +125°C 22-Pin CERDIP
MIC5801BV MIC5801YV 0°C to +85°C 28-Pin PLCC
MIC5801BWM MIC5801YWM 0°C to +85°C 24-Pin SOIC

1. Standard Military Drawing number for MIC5801AJBQ.

To view the Portable Document Format files (PDFs) on this site, download a free Acrobat Reader. The free Adobe Acrobat Reader allows you to view, navigate and print PDF files across many different platforms. If you wish to download a copy of the free Adobe Acrobat Reader please click on the