Print
MIC23099

MIC23099: Single AA/AAA Cell Step-Up/Step-Down Regulators with Battery Monitoring

Key Features
  • VIN range from 0.85V to 1.6V
  • VOUT1 (step-up) adjustable from 1.8V to 3.3V
  • VOUT2 (step-down) adjustable from 1.0V to VOUT2
  • VOUT1/400mW and VOUT2/30mA from a single cell
  • Minimizes switching noise in the audio band
  • Step-up regulator with output disconnect in shutdown
  • VOUT1, above 90% efficiency for 5mA to 200mA
  • Anti-ringing control circuit to minimize EMI
  • Turn-on inrush current limiting and soft-start
  • Automatic output discharge
  • Low-battery indicator
  • Power Good (PG) output
  • Low output ripple < 10mV
  • Short-circuit and thermal protection
  • 14-pin 2.5mm × 2.5mm × 0.55mm thin QFN (TQFN) package
  • -40°C to +125°C junction temperature range
Typical Application



Enlarge View

Related Information

Data Sheet
Product Brief
Eval Boards / Kit
Software Package / Kit
Application Notes
Package Outlines
MICRELSim Center
SPICE / IBIS Models
Distributor Stock Check
Free Samples
Press Releases
Related Literature
Applications
  • Audio headsets
  • Portable applications


General Description

The MIC23099 is a high-efficiency, low-noise, dual-output, integrated power-management solution for single-cell alkaline or NiMH battery applications. The synchronous boost output voltage (VOUT1) is enabled first and is powered from the battery. Next the synchronous buck output (VOUT2), which is powered from the boost output voltage, is enabled. This configuration allows VOUT2 to be independent of battery voltage, thereby allowing the buck output voltage to be higher or lower than the battery voltage.

To minimize switching artifacts in the audio band, both the converters are design to operate with a minimum switching frequency of 80kHz for the buck and 100kHz for the boost. The high current boost has a maximum switching frequency of 1MHz, minimizing the solution footprint.

The MIC23099 incorporates both battery-management functions and fault protection. The low-battery level is indicated by an external LED connected to the LED pin. In addition, a supervisory circuit monitors each output and asserts a power-good (PG) signal when the sequencing is done or de-asserted when a fault condition occurs.

Ordering Information
Part Number Marking(1) Output Voltages Junction Temp. Range Package(2) Lead Finish
MIC23099YFT 23099 Adjustable -40°C to +125°C 14-Pin 2.5mm x 2.5mm x 0.55mm TQFN Pb-Free

1. Pin 1 identifier symbol is "▲".
2. Thin QFN is a GREEN RoHS-compliant package. Lead finish is NiPdAu. Mold compound is Halogen Free.

To view the Portable Document Format files (PDFs) on this site, download a free Acrobat Reader. The free Adobe Acrobat Reader allows you to view, navigate and print PDF files across many different platforms. If you wish to download a copy of the free Adobe Acrobat Reader please click on the